Differences

This shows you the differences between two versions of the page.

--- tanszek:oktatas:techcomm:nutcracker_assembly_tutorial [2026/11/08 17:33] – kissa
+++ tanszek:oktatas:techcomm:nutcracker_assembly_tutorial [2026/11/08 17:39] (current) – [Set movement limits] kissa
@@ Line 69: / Line 69: @@
 {{:tanszek:oktatas:techcomm:pasted:20261108-171147.png}}
-Check the position of Handle before accepting the Mate. If the parts face the wrong direction, use **Flip primary axis** to reverse the Mate connector's Z-axis direction. If the part needs a different orientation around this axis, use **Reorient secondary axis**.
+Check the position of Handle before accepting the Mate. If the parts face the wrong direction, use **Flip primary axis** to reverse the Mate connector's Z-axis direction.
 {{:tanszek:oktatas:techcomm:pasted:20261108-171242.png}}
@@ Line 102: / Line 102: @@
 Without limits, a Slider Mate may allow the part to move farther than it should. To define an appropriate range of motion, enable **Limits** in the Slider Mate dialog (1).
-You can drag the part to test its movement (2). Onshape displays the displacement value in the graphics area. Use this value to estimate suitable minimum and maximum positions.
+You can drag the part to test its movement (2). Onshape displays the displacement value in the graphics area (3). Use this value to estimate suitable minimum and maximum positions.
 {{:tanszek:oktatas:techcomm:pasted:20261108-171652.png}}